Focus on manufacturing color stone coated roofing tiles for 16 years high-end products make high-end brand.

How to deal with the color stone metal tile slipping

by:New Sunlight Roof      2021-06-18
When installing the colored stone metal tiles at the eaves, you need to pay special attention. If you don't handle it well, it will easily fall off. What should you do? First of all, we need to understand the length of extension. The length of the main tile extending out of the eaves should be 30 mm, not too long or too short. Secondly, an additional layer of waterproof cushion should be added to the cornice, and the width should not be less than 900mm. Finally, when the eaves are not eaves, ventilated eaves are used to seal the eaves, and the upper and lower ends of the ventilated eaves are directly fixed on the upper and lower ends of the hanging tiles, and the long wooden slats are used to fix the wall; when the eaves are eaves, the eaves The tiles are laid over the cornice and extend 30mm from the cornice. The above are some issues that need to be paid attention to when dealing with colored stone tiles, so you can refer to them when installing. The treatment of the roof affects the future use. When there is a problem, the repair will not be the same, and there will be many defects, which will seriously cause water leakage. The installation of the ridge tile is also the same. Let’s first understand what details are needed. deal with? The first thing to do is to cut off the remaining part of the main tile and the ridge tile (including the main ridge and the oblique ridge), leaving a width of 5cm. Then fold it up by 5cm and fix it with nails on the ridge tile hanging tile, then buckle the ridge tile on it, and use self-tapping nails to fix it on the two sides with the hanging tile. Each piece of round ridge tile or angle ridge tile is fixed 4 self-tapping screws, each square ridge tile self-tapping screw spacing 40cm. Special end caps must be installed at both ends of the main ridge and the outer end of the oblique ridge, and pull rivets are used for installation. Finally, check that the ridge tiles should be straight after installation, without undulations and distortions, so that the roof outline is neat and beautiful. After all processing, pay attention to the overall inspection, because a little sloppy directly affects the later use effect. Tag: colored stone metal tile, colored stone coated steel roof tile construction, (816)
sheet metal roofing metal roofing supplier, device for producing sheet metal roofing, sheet metal roofing, and other sheet metal roofing, consisting of sheet metal roofing.
Foshan New Sunlight Roof Co.,Ltd builds value for our investors through the strength of our customers’ satisfaction and by consistently producing superior operating results.
Foshan New Sunlight Roof Co.,Ltd offers not only the high-quality product but also the finest service, gives the customer with an expressive using experience.
With this competency, Foshan New Sunlight Roof Co.,Ltd provide high technology and assist customers to create added value and contribute to the development of producing metal roofing supplier.
Custom message
Chat Online
Chat Online
Chat Online inputting...
Sign in with: